ZEROPLAY Miter Bars’ ONE-TOUCH-CALIBRATION® adjusts using a system of opposing ramps. The two halves expand and contract to fill the entire slot.
- Top-down installation lets you keep your sled square to the fence while you secure the ZEROPLAY Miter Bar for a hassle-free setup and precision cuts.
- Includes (2) ZEROPLAY Miter Bars for larger/longer sleds and (2) ZEROPLAY Miter Stops.
- Fits any standard 3/4” x 3/8” T-Track Miter Slots.
ZEROPLAY Miter Bars will fit any standard (3/4” x 3/8”) miter slot that measures between 0.73″ and 0.79″ wide and is at least 5/16″ deep.
Compatible miter tracks include but not exclusive to ShopSmith, SawStop, Bosch 4100, Delta Unisaw, Powermatic, Rigid, Dewalt, and General 350 Tracks.
*Not compatible with table saws with tabs cast into the top of the miter slot or 5/8″ miter slots i.e. Ryobi or Craftsman.
The defining feature and flaw of aftermarket miter bars are one in the same – set screws. Frustrated with the difficulty of fitting miter bars with set screws, Founder and inventor, Henry Wang, set out to change it. He conceived a method of adjustment based on opposing wedges, that adjusted the entire bar evenly in a single motion. With its ONE-TOUCH CALIBRATION® and top-down installation, the age-old struggles of sled making had finally been solved.
